Clip-Rail Pipe Track — 1 m Lengths (Box of 100)

Clip-Rail Pipe Track — 1 m Lengths (Box of 100)

Build dead-straight, evenly-spaced loops in a fraction of the time. These rigid clip-rails snap-fit over 16 mm – 20 mm PERT / PEX / MLCP pipe, locking each circuit to the insulation so securely you can walk the slab before the screed goes down.

Why installers reach for rail

• Perfect pipe spacing – moulded saddles every 50 mm keep centres bang-on, eliminating tape measures and chalk lines.

• Snap-fit grip – tapered jaws bite the pipe but release cleanly if you need to tweak a loop.

• Interlock & extend – male/female dovetail ends let you join rails into any length with no gaps or misalignment.

• Stick, staple or screw – integrated peel-&-stick foam tape bonds to foil-faced PIR, while side flanges accept 40 mm staples for EPS boards.

• Heavy-duty polypropylene – impact-resistant, non-corrosive and safe in cementitious screeds or gypsum flowing compounds.

Technical snapshot

Coverage & pack contents

• 100 rails × 1 m = 100 m total track
  • At 150 mm pipe centres this covers ≈ 15 m² of floor area.

• Supplied in a sturdy cardboard carton for clean site storage and quick counting.

Installer tip: Lay one rail at each grid line, snap the pipe in with your clip gun’s 40 mm red clips and you’ll fly through an average 50 m² slab in under an hour.

Add a box to your cart and give every RBSI underfloor heating job the straight, professional finish clients notice.